1. Inspection must be done before driving
2. Signal should be given 5m away when there is someone in front of you during driving
3. The driving speed in the factory should not exceed 15 km/h, and the speed should not exceed 10 km/h in other complex areas such as factory gates, elevators, turns, crowded areas, narrow passages, etc.
4. The lowest point of the cargo should be 0.3m~0.4m above the ground when driving
5. Turning should not be too sharp to prevent the tendency of "free turning"
6. Going up and down the slope should be slow and at a constant speed, and turning on the slope is not allowed
7. Do not drive across the slope. When the slope is greater than 10%, reverse driving should be used when going downhill
8. When the forklift driver is carrying goods forward, if large or heavy goods are in the driver's sight, reverse driving should be adopted
1. Single fork operation is not allowed
2. It is not allowed to lift the goods for long distances
3. It is not allowed to use the fork to pick up the goods by flipping the pallet
4. It is not allowed to use the fork to directly shovel chemicals, flammables and other hazardous chemicals
5. It is not allowed to use inertia force to pick up goods
6. It is not allowed to use braking force to release round or easy-to-roll objects
7. It is not allowed to carry people on the pallet or fork to work, and it is strictly forbidden to stand under the fork after the fork is raised
8. It is not allowed to drive horizontally on a slope
